Recent content by Canario

Maybe check if all the cables are still attached (the dark flat ones) maybe one came lose

have you done all firmware upgrades already?

yes, did refresh several times, downgrade, upgrade, factory reset, upgrade again - problem persisted in any constellation (there was never an issue with updating)

It's more like a temporary solution - that one needs to be sent in, no question, the gimbal motor is faulty for some reason. But with those tests someone may be able to track down an issue and may use the drone for some urgent work before sending it in and wait several weeks for getting another...

did refresh several times, downgrade, upgrade, factory reset, upgrade again - problem persisted. This was the only thing, that actually worked: may look funny, but that big coin on the back off the camera has finally eliminated buzzing and jello - if I remove it, buzzing/jello comes back

I've just "glued" a coin on the back of the camera - the buzzing and jello is gone? I already tried a 1(euro)cent coin on the side to balance the gimbal, now another coin on the back of the cam - gimbal is now in full balance when turned off. Will do more tests, but I was not able to produce...

no, not at all unfortunately

was there any fix for it .. ? I can tell it is the topmost gimbal motor producing it, with buzzing it gets very hot also seems like it wants to stabilize its OWN vibration - you can calm it down by just touching it or tilting the aircraft forward - anyway, even the slightest "shock" will make...

not sure yet - for me it seems either the gimbal motor has some fault or software is delivering wrong signals to the gimbal or the cam is just to heavy inducing too much stress on some gimbal motors. Try pushing your vibrating gimbal with your finger if it stops vibrating then (see vid in #40)...

Yea look here, the vibrating is only there, when gimbal is in a certain position (following is during flight)

Hi there - some guy pointed me to this in DJI Forum, after I reported the same problem on my P4P. I've already found this thread before, but decided to join here :) My P4P had the Gimbal Lock (the hard plastik bracket) also mounted a bit to far to the center and maybe have stressed the gimbal...