Kind of looks like it has a Immersion RC Tx. Question would be which one? I personally would want the Tx antenna pointed down and not out the side like he has it. You'll get more range that way. Also that controller is not the V2.0 so it might be a V1.0 P2 which in my opinion not a bad thing. I...
From B&H:
The Anti-Interference Board for Zenmuse H3-3D from DJI is used when installing the H3-3D on the Phantom 2, and fits between 8-pin cable and the G8 port on the gimbal. It filters the power being supplied to the gimbal to help minimize any interference with the video signal. It is...
Install was actually quite easy. Absolutely love how it works. Just need to cycle S2 2x and the gear open. Cycle S1 1x and they close. I haven't noticed a big difference. I can usually go about 15 min to about 25% on the battery.
I had the same problem and when I went to the h3-3d it got worse. Even was getting a shot of the gear when the camera was pointing forward and I turned to the right. Got a set of these and problem solved.
RCDH RETRACT LANDING GEAR FOR DJI PHANTOM 2
Wow. That's a terrible experience. I would be furious. FWIW both of mine have been flying fine with no issues other than the j hook. One on firmware 1.8 and the other on 2.0. Good luck to you.
IMO it's not hard at all. Just take your time and make sure you put the correct screws in the correct location. I would also suggest taking pictures of the connectors especially on the Naza so you put the connectors back in the original location. They could be easy plugged in wrong. Also make...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.