Recent content by BZMac

I have to say that Im not impressed with the 450 frame. Once I started adding the electronic components I realized how heavy it would be, not to mention how impractical the actual layout of the trays are. Im debating to just order some raw carbon fiber and build my own frame.

I was planning on it.what do you think?

Venom 35C 2S 7.4V 10000mAh LiPO Battery with Universal Plug System https://www.amazon.com/dp/B00E94LNIG/ref=cm_sw_r_awd_u0nPvbYKCNFM3 https://www.amazon.com/dp/B00E94LNIG/ref=cm_sw_r_awd_u0nPvbYKCNFM3 Not sure if anyone has seen these, but I just began working on an SK450. I plan to use phantom...

I'm on Martha's Vineyard, if you come out this way, send a message.

Thanks so much for your help - you're my hero.

I'm looking at the schematic, I think I've ID'd them properly. Just a bit hard to navigate them using my tablet.

C19 appears the be the same exact piece as d9/10... Any idea what that is, or what the value is?

Interesting, I cant figure out d 9 and 10 either.

Thanks for the schematic, big help! It's c1, d9 and d10. Any idea what they are and what they control?

http://www.flying-hobby.com/images/large/DJI-PV-P10/DJI-PV-P10_000.jpg Greetings all... While inspecting my circuitboard post crash, I noticed three tiny pieces missing. They are located directly above the PMU white box on the right hand side in the picture above. Sorry for the terrible...

Well, I'm not saying the esc damage was mid-flight, but a result. But this happened about 2 minutes into flight, and it seems as if one of the props died mid air, thus on the video you can see it turn and begin to crash. When I noticed that something wasn't right, I begun FS mode, and let go of...

I haven't begun to assess the damage, but the frame is cracked (top and bottom), motor will not turn (seems as if one of the magnets is catching), gimbal arm is cracked. My last crash happened in the same manner. It makes me wonder if it has been an ongoing problem I never noticed, but have been...

I took a crash today, cracked the frame. If you watch the video you can see the props at one point, I think one of my motors ceased. After that, it just turns over and starts going down. Im thinking about going with the X450 frame. Any suggestions?

Greetings all - I'm flying a phantom 2 v2 with a walker a G2D gimbal. I have the gimbal controllable with the X1 on the remote, and was curious how to make an adjustment so the gimbal angle will remain in position when I let go of the X1? Currently I either have to hold the X1 aND try to...

Did you remove any wiring from the naza unit? Mine turned out to be one of the naza connections I put in backwards.