Hi,
I read a lot of threads here about the P3 flat "con board / main board" ribbon cable.
It's a very sensible cable that you can damage when your open or the RC or manipulate it with a pliers.
I damaged mine when I installed the DBS mod (topic here : iPad not recognized after DBS itelite mod)...
Yes, I tried multiple times.
Previous pics are just to show the ribbon little damages.
Attached, the the final pic of the RC when a made tests. Ribbon connections are correctly aligned.
More infos :
- RC is correctly bind (green led when the drone is on)
- I can start motors, everything works
- I remember that C1 pulled the camera down when pressed. Now it emit a "beep" but the camera doesn't move.
I think my clamp may damage the ribbon, but i'm not sure. Attached some pics...
Hi,
I just install the itelite DBS mod, but now my iPad seems not be recognized by the RC.
The ribbon cable seems to be correctly plugged.
What went wrong?
Thanks a lot for your help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.