Hi everyone, I've been so busy with my job the last few months I haven't really been able to check up on this thread since. My website was down for migration a couple of days ago. I double checked my link and it does indeed work, so it SHOULD work for you now. :)
Also, I can say that after...
I think the physical installation will be the same except for the channel/port you use on the receiver. The software profile will not work, BUT if you follow llavalle's tutorial located here it should resemble in configuration.
Yes, if you call or email a technician they will send you the...
Not sure what radio you had in mind but I just finished a tutorial for the Futaba T14SG last night, here's the link.
viewtopic.php?f=19&t=6205
It's a fantastic radio, you should look into it. :)
Ok, it took me WAY longer than I thought it would but I got the tutorial done, here's the link! Complete with a 14SG profile and everything...
viewtopic.php?f=19&t=6205
Re: Tutorial For 14SG and DJI Phantom 2
Part 2 - The Transmitter Setup
Prerequisites:
1. You've completed "Part 1 - The Physical Installation" of this tutorial.
2. You have the Phantom 2 Assistant Software installed and working.
3. You have an SD card on hand (SD: 32MB-2GB or SDHC 4GB-32GB)...
Greetings everyone, I promised a tutorial so here it is!
Special thanks to llavalle because I used one of his pictures and this is basically a conversion of his original tutorial for the Phantom 1 located here. Also thanks to peec for helping me and basically directing me to llavalle's tutorial...
I removed the stock Rx, run your new antennas out the left front leg, put one next to the canbus the other 90 degree on the body, you'll see mine in my pics.
I just left the cable connected to the stock Rx when I pulled it out.
I'm using sbus2 port by the way, also do not let anything touch...
You can expect it Saturday evening, should take me 1-2 hours to write it. Also have to teach myself how to export the profile out of the transmitter.
It's 4 in morning and I'm still working on computers at my work, lol.
Just letting you guys know I haven't forgotten about the tutorial I've promised, the weather here this week has been terrible and I've been sick, will end up doing the tutorial this weekend at the latest.
I flew mine today 500 meters away 250 meters up with no problem, I was only limited by my FPV which for some reason was randomly getting interference from something.
I will make an instructional and possibly post the profile to my 14SG in a new topic, give me a day or so. I took pretty good...
I already figured it out through trial and error, I have a dual rate for the rudder set, a throttle curve I'm still tinkering with, and a prog mix for the fail safe, this transmitter is amazing but it gives me a headache lol.
Ok, I have my P2 torn apart and the stock Rx removed, but which one of the plugs off the stock Rx do I wire into the new reciever? P2 is dual antenna so the tutorials on the internet aren't helping me.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.