Recent content by bobhaole

Thanks for your reply! Yes the SR6 does have PPM. Hopefully everything will pair up. Thanks again!

I have an extra DJ6 controller with no receiver and an SR6 controller with receiver but is currently being used in my phantom 1.5 We are building an autonomous drone for a school project and I am wondering if I would be able to test the system with using the DJI transmitter instead of having to...

I also suggest just having the phantom hover just above you and catch it by one of the legs. Much easier and less time consuming trying to land it on the ground especially in the wind.

I have had the same problem with my Walkera G-3D. Spent hours trying to figure it out in just re-calibrating the lever through the NAZA assistant with no luck. I have not researched it much but I will eventually get on this and update you as I go along.

Seen that one and was debating but more so looking for a complete kit and also considering what Green_Phantom said about it being trash now steers me away from it How much was it? Might have to go this route unless I can find a spare controller to rip parts from

Anyone with a V1 with non-autocentering throttle do a conversion to autocenter? Getting frustrated having the drone far away and can't tell if I'm climbing or falling, especially since I don't have an FPV setup yet. Here's a site a found but can't find any similar ones and its out of stock for...

can you tilt the gimbal manually with the controls on the control board?

Lipos do die after a while. Some sooner then others. Best thing to do is top off your batteries right before you fly and do a discharge cycle (if you have a lipo charger with that feature) in my opinion after 2-4 cycles on that battery. Yes they do lose charge if you haven't used them in some...

Re: 9" Prop Upgrade - Takes Off I would keep researching. There are probably lots of info that you haven't come across yet. As for me, I have researched many different props and finally decided to just try the stock 9" props but clone versions for my V1 as a reference and maybe to build on top...

Re: 9" Prop Upgrade - Takes Off I'm sure with a good balance to them and finding the gains to match them they could be very good but that could also go the opposite way and be terrible

Re: 9" Prop Upgrade - Takes Off Shot the gun and put my gimbal on with gopro hero 3 and it no longer wants to shoot off from take off. My default gains in Naza assistant were: 125 125 100 100 100 100 I believe my test gains were: 135 135 115 115 115 115 This test I felt was ok so I decided...

Re: 9" Prop Upgrade - Takes Off Thanks for your reply, it does help. I have not re-calibrated the drone or the sticks before my quick test flight due to I did not think I had to since I have been flying with the stock 8" props perfectly fine. I may try that and test again. I do not have the...

I have recently upgraded my Phantom V1 to some clone Vision props, not self-tightening. I got these props from Amazon, recently listed and I believe I am the first purchaser. Here is the link to them. http://www.amazon.com/gp/product/B00MA6KGBA/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 My...