Yes, you can . My S2 in the off position quit. It would jump to course lock even though it was in the upper position. You could put pressure on it and it would make connection. It is a common three position switch on-off-on. If position two and three work, just change top and bottom wire...
In NASA mode, the S1switch-- the one on the right has three positions. By default, its GPS, Atti, Atti. You can set the third position to Atti, manual or the return to home.
Just three wires to solder. Pretty easy if you have soldered before. Took longer to unscrew the old switch than to put the new one in. Just make sure the wires go in the same position as before. Like I said earlier, you can take it out of nasa mode and continue to fly it until you get it fixed...
I have only seen one other post about a bad switch. I can't remember if it was on this forum or somewhere else. I first noticed that I was having trouble setting a new home position by toggling the S2 switch. Some time it would work and some time it wouldn't. When the control would reverse...
Re: 3rd Vision Flight in Houston - Question
Yeah, I almost ran into a tree before I realized my controls were backward. Mine would switch from the off position to course lock back and forth by itself. Immediately landed. Put a meter on both switches. It made good connection in course lock...
Re: 3rd Vision Flight in Houston - Question
My phantom vision did the same thing not too long after I purchased it. I traced it to the S2 switch.. I would have the S2 switch in the off position and it would switch to course lock by itself, which, of course made the control different. It turned...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.