I had my P3A flying for five min. a few weeks ago and a prop flew off during a stationary hover. Pretty convinced that it was a ESC or physical motor lockup that caused it.
It has been sent to DJI and I am waiting on word from them as we speak.
Makes me nervous when flying my P3P that something...
Right? I sure hope they take care of me.
The video is pretty short. No video after just a few seconds of the death spin, but you can clearly see the arm and motor with no prop when the video is paused because the gimble looked up at the side that was falling.
I posted on multiple threds in an attempt to get help. There seemed to be a problem with that so I therefor deleted the repetive posts.
Is that a problem?
Just here looking for help
Thank you for your replies.
They were snugged up with the tool. I think that the motor must have stopped either through a jam or an ESC problem of some type.
I had my phantom 3 pro fall from 400 ft yesterday to be totaled. From reviewing the video we can see a prop fly off during a hovering shot and then the bare arm and motor in frame as the bird came down. Props were all snugged on before flight.
Found undamaged prop 25 yards away. Upon inspecting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.