Recent content by billn

Looks like something is wrong. My Taranis Plus is new enough that the SWR works and I have a low SWR and good RSSI and have never had any problems. I have the two antenna's on the receiver in a V away from the FPV tx. For the issues with the Orange TX I have only used it with the nano. I just...

Hi Bill, when amber gives you voltage alerts do you get detailed alerts such as 12.2 or 11.9 volts. I am only getting 12 or 11 volts with no . value. I am using it with a 4S battery so 16, 15, 14 volts is good. Get to 13 and it's time to bring it home. And you still have the detailed info on...

I have seen some strange things with the orange module. I was seeing the same thing, often needing to rebind after changing the battery in the nano. What I found as a solution was to reset the flight (which also resets the timer). Press and hold the ent button (lower right), then choose reset...

There are actually a couple of things. I have the dual rates set up so when I want to fly easy I put it into low rates but most of the time I leave it in high rates. That's on the SD switch. The SH switch is flight mode, to switch between Stability and Agility mode (fly it like you stole it)...

What kind of micro do you have? Some fly better than others. One thing I have found is that its a lot easier to control if you keep it moving forward. Bill

Just noticed something in the eepe. I use a this basic file for all bind and fly craft Its the way Spectrem sets up all the 4/5/6 channel TX. For SH (Switch H) says panic which it is for a delta, but with the nano SH is what you use to change modes.

Just so you know - you have cost me $$$ Looking at you fleet is what get me to buy the Nano's and Hubsan. I also grew up down your way in East Providence. I did programming for many years so I view the Taranis programming as in input and some mods, mixing of inputs, outputs. It seems to work...

On my QAV I have 16 channels on one receiver, the first 8 on the S-BUS into the NAZA and the second 8 to the 8 set of pins. Bill

I can't say that I am a Taranis "EXPERT" but have learned alot about using it this winter. Being another frozen in New England flyer there has been lots of time to play with it. It is great for the geeks with a really different view of how to set up models and you can do almost anything. So I...

I agree with you. What you have shown is from the NAZA-M manual and the Phantom manual says it a little differently. In the Phantom manual it says that if its "4.2 Initiating the Failsafe mode from different flying statuses will result in different processes. Ready to Fly(NON-GPS)-Automatic...

Re: New database promises drone no-fly zone around your hous Steve has heard be before, I would like to propose a no phone zone list, where the phone makers using the internal GPS must disable the camera when it is on one of these zones. I can hear a drone but I can hear someone on foot...

Re: Frsky Taranis X9D Plus users, both stick return to cente You would need to make a module to plug in that had a 5.8 transmitter. I am going to look for a DJI 5.8 Tx and take it apart and see if I can make a module. I already have modules to TacTic and Spectrum so I can use there bind and...

Both Phone is a 4s and a Samsung Tab Pro 8.4 with a custom bracket to hold it.

Re: Frsky Taranis X9D Plus users, both stick return to cente On my QAV400 I use the Naza M V2 FC (like the Phantom) and have a Spectrum receiver. I either use my DX6 or the Taranis (with the orange module) to fly it. On the DX6 I have the spring enabled but I don't on the Taranis, instead I...

Re: Frsky Taranis X9D Plus users, both stick return to cente Its in the manual, open it up, and turn the mode screw - it will engage the spring.