Recent content by Aship005

A phantom 2. Attached is a link of what's happening. I didn't record the transmitter, but basically I try and go slowly up and in the beginning you can see it jitters and sometimes even goes down. When I let go of the scroll the gimbal jitters a little too. (video is still loading but this is...

I noticed my gimbal was shaky, so I bought new remote thinking it was that. That hasn't fixed it. I have reset the gimbal and done a calibration, but it still jerks/ goes up and down if I try and go slow with gimbal tilt or when I stop at it's maximum it jerks a little. I am trying to figure...

Okay, That worked. I had it in the old version not the updated version. But, now when I try and scroll up it the gimbal kinda shakes or stutters. Especially when I let go of the wheel, go really slow. This problem seems to be only when I am scrolling up. Could this be a gimbal problem or still...

So, I just bought the newer remote with the scroll wheel for my phantom 2, but it is doing something I'm not sure it is suppose to do. Whenever I scroll up or down it works, but it always goes back to it's original position. An example is if I scroll down the gimbal with go-pro will go down, but...

When I first bought and used my DJI phantom, I would receive a blinking and loud beep from my remote when the battery was low. Now that I have introduced a black Pearl FPV system it doesn't warn me when the battery is low. Did I just accidentally mess something up with the settings? I am also...

1. As far as turning things on in the correct order... First I turn on my DJI remote control with Black Pearl receiver. Then I turn on the DJI copter itself with transmitter? All antennas attached of course. The reason I ask is b/c my Immersion RC 600mw transmitter seems to be getting very hot...

1. As far as turning things on in the correct order... First I turn on my DJI remote control with Black Pearl receiver. Then I turn on the DJI copter itself with transmitter? All antennas attached of course. The reason I ask is b/c my Immersion RC 600mw transmitter seems to be getting very hot...

So I what to purchase a fpv system for my p2 with h3 3d gimbal. Below is what I was going to purchase. Is this a good set up? How complicated b/c I have been watching a ton of YouTube videos to try and figure it out. Lastly, is it worth it to buy the ground station set up for the iPad? My fear...