Recent content by ARThompson

Here is a picture taken with this mount, reduced from 5Mb to about 500Kb, which unfortunately loses quite a lot of detail. ALAN

My earlier camera mount did not work very well. The pictures were badly affected by vibration. So I've made a new version which is very simple and comprises a modified P1 anti-jello mount (if you drill carbon fibre be very careful of the dust) and a bracket made from 1.2mm aluminium. It has...

Here is my (experimental, as yet untested) version. The camera (Canon A2400IS) is 126gm, plus mount gives just under 200gm. It is based on a mount which is used to fix a camera to a car windscreen, which I have substantially modified and drilled. I've put in anti-vibration washers, but I...

hughsnews, I was interested to see your posting. I am an amateur archaeologist based in Inverness, Scotland, and I've independently come to much the same conclusions. I rejected the GoPro (too wide angle), and have bought a small Canon camera A2400IS (126gm incl battery), and also used CHDK to...

I'm also new and have a similar issue. The release note dated January 9, 2014 says update remote controller firmware to V1.0.1.11. I just got my Phantom 2 (non-vision, no H3-2D) and have been following through the User Manual v1.04. I got to section 7, downloaded the Driver and Assistant...