Recent content by armour

Hi, I dont have a 4k to help you out with the board but I can tell you that when my p3s aircraft was bricked, even after fixing the rc, it would not bind to the aircraft so yes, once your aircraft is bricked you will experience this problem. Can you confirm there is no labels for rx and tx on...

Ouch indeed, I'm assuming you installed the arduino Windows drivers as well on the computer right? If that's the case, the board sounds dead and unfortunately you may have to replace the board altogether Sorry I can't help you further :(

Hey! You've connected the Arduino wrongly! That's why! There is hope for your drone once it didn't damage the drone board due to the wrong connection... Here is what to do, based on your pictures Remove the jumper cable from the AREF pins (Where did you get instructions to do that???) Instead...

My email address is [email protected]

Just an update since it seems this thread has been mostly inactive/dead from the previous posters who seemed to fixed theirs. MY RC AND AIRCRAFT HAS BEEN RESTORED! Thanks to all who posted instructions for solutions! Just to clarify: I used the Raspberry PI 2 B model to fix the Remote...

That's strange, the only way you could ruin the system images or the files would be if you edited more than the rcS files. Were you able to connect via UART before and tried to fix the files and now you cannot connect OR you've not been able to connect at all? I think you should double check...

I believe he is referring to the serial to TTL device to connect the computer to the drone. My aircraft is still bricked and from a few posts it seems the Arduino or Serial to TTL can fix it. I am hoping that this works since the raspberry pi is not communicated with the aircraft (only got it to...

Hi Jack, could you please post PDF? Thanks

I was able to get the remote controller booting again using the PI but I can't seem to get the PI to communicate with the aircraft to fix boot - nothing shows. Can anyone confirm the aircraft TTL is 3.3v or 5v? The remote is not pairing with the aircraft so now I'm assuming the aircraft needs...

Hi, I just bricked mine as well, very surprised since I used WinSCP which I normally use when coding in linux. Have a few quick questions 1. Can I use a Raspberry Pi to connect to the RC's TX and RX? The pi has 3.3v RX and TX but afraid to connect. Don't want to damage the pi 2. Can someone post...