Recent content by andy869

Phantom 4 up for sale with many extras! Always adult flown, firmware UTD, no issues whatsoever. Never crashed. It has about 60 flights on it. I had DBS mods put on their long range patch antenna, simply amazing, I've been out 6.25 one way with absolutely perfect reception. I also have the...

Flying 60 feet below normal operating ceiling, into airspace allowed for drones, and you are pissed YOU hit a drone? Ok Dude. Probably was a bird anyway.

Really??? You didn't think this might be a problem? You should not have needed a "lesson". Common sense man.

Make sure the update didnt switch the "hardware decoding" to something you don't want.

In DJI go, click the three dots in the upper right, then on the left tab click "HD" icon. 3rd setting down: "Simultaneous image output to app and HDMI". Click it on. I'm running FIrmware 1.02.0503, as im afraid to update anything because it just works. It took me a while of upgrading and...

Sure about that? The research I've done shows the amount of reported Iphones exploding since their release is about as many Samsungs that blew up last week. Yikes. I trust Apple's build quality over anyone else's. But I apologize for even the semblance of being "that guy" apple vs. whoever...

Upgrade Drone firmware, then RC firmware. Completely erase DJI go app and download the newest version. Restart everything, check settings. I had about 2 hours of hair ripping out getting my HDMI and RC to work properly. Proper order and upgrading got me sorted out. Also, make sure you have...

He probably has beginner mode checked.

Litchi is the best out there that I have found. The only software that can smoothly and easily set waypoints and operate the camera professionally. Great vid, but you really need to adjust your gimbal your horizon is like 3 degrees off!

This may or may not relate but after installing my module I had to reboot not respring my Ipad mini to get it to connect back with the drone.

I had issues installing mine but I solved it by rebooting my Ipad Mini.

I fixed my issue, turns out the Ipad mini needed to be rebooted, the app wasn't working. When I used my Iphone to setup, everything worked fine.

I tried installing the firmware, it just sits and beeps at 0%. Installed my old board and the same thing. Did I just brick my controller? So frustrated, this should be simple and I just wasted 3 hours. Ok, got my old module back in, everything works. I just don't get it. I've tried two...

Pulling off the back of the module, I now can see firmware updates and it connects to the bird, however the only firmware option is a downgrade.

Yeah, I was very careful putting all the ribbons back in. I did it and re-did it multiple times with different modules. At this point I am getting no communication to the bird, and no options for firmware downloading. Forcing a firmware download I am prompted to select "NONE" for firmware...