Recent content by Alfo40

  1. A

    ARRIS CM2000 Brushless Gimbal for GoPro

    I've made my first flight with Arris CM2000 and I was blown away from the great steady video recorded. It has been pretty much plug and play and I'm not planning to hook it up to the 7th channel at this time.
  2. A

    Indoor flying...anyone really doing it?

    I've hovered few times but my house is too small to fly and beside the Phantom with the new firmware is very stable, the ground/wall effects in a tight environment can really turn it in a challenge.
  3. A

    Battery voltage setting?

    Where is your loss value? It is supposed to be around 0,60 for both alarms. I've set mine to 11,10V and 10,90V and getting 11/12 minutes out of 2200 batteries. In the end I can recharge 1100+ mha so it might be a little too much (I'm thinking about going up to 11,20 for the first alarm)
  4. A

    Needing 5 volts for FPV

    Wait! From F1 port in the Naza you get the 5volts you need, without putting any extra weight on the Phantom. Just remember to disconnect the signal wire from the plug (generally is the white wire, you only need red and black one) or you will get an OFF signal and the tx won't go ON. If you...
  5. A

    Anyone using the Rc Logger FPV system?

    Here I come! Got the RC Logger System and installed on the Phantom. I've basically taken the power for the transmitter out of the NAZA F1 port (need to open the top of the Phantom, 12 screws plus blade's nuts, run the power wire through one rubber sealed hole close to the landing gear mount...
  6. A

    Anyone using the Rc Logger FPV system?

    Hi! I've seen the system from a friend of mine but not installed on the drone yet. He showed me it working with the gopro3 and the result is more than decent. The total package is very small and handy so I've already ordered one set for my Phantom and I'll be ready to give you a reliable answer...