The last three flights I have been getting weak and poor image on the video downlink. Never have had this before all up to date in all my firmware. It's so bad I can't see anything on my display when running the camera ! At times it's just a black screen and flickers in and out. I thought I was...
Good luck with that after reading all the post in this forum about sudden power failure issues. I would never fly with battery below 100%. Battery might read 80% but that not under a load once a load is applied you could see voltage drop to unsafe levels very quickly.
Why would your battery say 70 percent at the start of the flight. If that was the case that was your problem. It indicates 70 percent them under a load it drops to unsafe battery level. DJI says always use a fully charged battery 100%. There has been a lot of post regarding this on this forum...
I agree wish I knew the cause of the crash. I believe that mine was a battery failure I pay a lot more attention to only fly with 100% on the battery. Also make I sure I cycle them more often.
Yesterday I got back my P3 Pro from DJI service California. Total time was 3 weeks to the day out and back. My P3 crashed from 160 feet 1 minute into the flight back in early November. The damage was major shell cracked boards in copter broken camera broken off gimbal was crushed. I brought it...
What was wrong with your P3P ? Did they fix it or replace it ? Mine had major damage and I haven't got it back yet it is in transit to me. Curious if they just replaced it instead of repair it. Camera was broken shell cracked gimbal damage main board crack and GPS board broken.
Well I have a different story. My Pro 3 fell from 160 after a 75% battery went to zero. I brought it to a local guy Skylabs out of Boston. He told me to send it to send to DJI his belief was it was a copter malfunction. With all the negative reports I heard from DJI I was not expecting anything...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.