IM CONCERNED THAT DJI WONT COVER THE CRASH I HAD AFTER FIRMWARE UPGRADE
I WAS HOVERING ON A JOB GETTING READY TO START FILMING A WAS UNDER A PALM WITH ABOUT 10 FEET AWAY FROM TRUNK I WAS HOVERING 6 FEET OF THE GROUND I TOOK MY EYES OF THE DRONE TO SET MY CAMERA SETTINGS WHEN MY DRONE HOVERD...
YES I TOOK MY GIMBAL APART AND REPLACED THE GIMBAL MOTOR AND MAGNET CUP PRESSEED OUT THE CUP BECAUSE THE MOTOR CHAFT WAS DIFFERENT SIZE SO THE CAP FROM VISION PLUS AND MOTOR I GOT FROM A OLD P 2 VISION PLUS HAS THE SAME MOTOR AS P 3 PRO GIMBAL AND THE MAGNET CUP OD SIZE IS THE SAME BUT...
DID YOU TURN ON THE P3 BEFORE LOCKING THE SET SCREW if the gimbal is cenerd
its good to go but if its side ways the yes you will need to loosen the set screw so now that it went wild did it stop wiggeling soon after
ok the gimbal arm is L shaped on the top you got to swivel to to see the pin thats locking the gimbal to the shaft if its not tight it will slide up and down on the shaft and vibrate and it also swivels on the shaft then it cant find a centering point start it diagnostic start up right after...
let me ask you a q or 2 did you replace the gible motors inside were the 5 screw plate is
the shafts are semi pressed on and need to be aligned if you crashed it and it hits the cam gible
it can loosen up on the shaft and spin on the shaft that is what my p 3 pro did also up on the shaft...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.