Recent content by ace5000

  1. A

    Anyone thinking about using the new P2 motors on their FC40?

    Re: Anyone thinking about using the new P2 motors on their F Anything else on this yet? I'm more than interested in the mod. I also wonder about battery time as well. Thanks.
  2. A

    fc40 charger

    My does not make a sound.
  3. A

    Low voltage alarm on way - Need advice

    OK many thanks, I'm starting to get this. So when I get the alarm - turn protection off in NAZA - and set the alarm to 3.5? Can I set the 2nd level protection to a low level like 10 so it never trips to land but I still get warning lights?
  4. A

    Low voltage alarm on way - Need advice

    Thanks, but there is loaded and non loaded settings I don't understand. Can you be more specific for the NAZA settings? Also, per my question, what voltage should I set the aftermarket alarm to on the battery?
  5. A

    Low voltage alarm on way - Need advice

    Hello Guys I'm new at this and have done some searching but am getting different answers... I am flying a stock FC40 with no minimal extra weight (a 2800 battery at times). 1. What should I set the low voltage limit at on the alarm which will be attached to the battery balance plug while...
  6. A

    New brushless gimbal for FC40 from Aerial Freaks

    If I can butt in here... What entry level gimbal would you recommend for the stock camera?
  7. A

    GPS tracker - Trackimo

    I've have been looking as various solutions to track my Phantom if it decides to take off on me. I found this GPS tracker which looks really interesting. It has it's own tracking subscription plan, with first 12 mos. free, - then $5 /mo. afterwards. trackimo.com It's $99 at newegg. Anyone...
  8. A

    Fly after compass calibration or power off?

    Ok, thanks! I was doing it in reverse...
  9. A

    Fly after compass calibration or power off?

    I can't seen to find this answer. After the compass dance, do you put it down quickly to get GPS lock - or power off and start again? Thanks.
  10. A

    Camera power switch not working in mount

    Ok good tips - thanks!
  11. A

    Camera power switch not working in mount

    Hello Again, The power button on the cam mount attached to the Phantom is not making contact? It looks like a mfg. fault. Has this been seen before? Thanks.
  12. A

    1st flight - Observations and issues

    Guys - thanks so much for the information. I now know how to check my home point by going to HP mode. I will also calibrate again.
  13. A

    1st flight - Observations and issues

    "Could be your compass was out of wack and not properly calibrated" OK, then I will do another IMU calibration. Anyone know anythong about the camera on off switch in the housing?
  14. A

    1st flight - Observations and issues

    Hello All, After all of my years in RC, I feel like I finally graduated to something really great. Before the flight I updated the firmware, and there was receiver update as well. I restored the defaults, performed an advanced calibration (per a video on YouTube), and turned on IOC. I also...
  15. A

    Low voltage cutoff

    I am also interested in recommended voltage settings for the firmware and for an audible lipo alarm.