Recent content by aadvanboven

.... You have to eliminate the changes from before one by one....

What if you keep the components on the p2 but doesn't turn the fpv transmitter on. Maybe the signal blocks the signal of the controller so it will go into failsafe. You have to el

Maybe with the extra payload your battery voltage drops quicker then before. What settings are you using for voltage protection within the Naza assistant ?

Nice, but isn't the signal better with the antenna below ?

I have the E300 set but the motors are just the same as the red mn2212's... Just in a grey version. I have checked the looks of the bearings but there is no sign of them being better then the former dji motors... Maybe in the long run, but for now i think it is more marketing. Verzonden vanaf...

When using the GS you define your multi-waypoint flightplan and 'upload' this into the Naza. When pressing GO it takes off and flies on its own. Also without a connection it will keep flying its program. You can always take over control with your TX by changing from GPS to ATT mode....

Hi, i have build a F550 and F450 and both are (now) stable as a rock :-) Few items to make sure: - Place your Naza exactly in the middle of the machine; - Put your GPS-puck on the stick above the Naza if possible. - Make sure that you know where your Center-of-Gravity (COG) is. And tell your...

Use the sub-trim to center the channel Verstuurd vanaf mijn Nexus 5 met Tapatalk

Hello all, I am in search of the placement and distances of the mounting holes on a P2. Is there someone who can make a closesup photo of the bottom of a P2 and measure the distances between the holes ? I need the info to create a quick-release mount for gimbals like I did on a P1. Thanks a...

Just received the printed Quick Release by Shapeways and it rocks. Very good quality. Photo's now on the Shapeway model page : http://www.shapeways.com/model/1649214/ ... erialId=76

Meer dan je denkt ! :D

To all, I have publiced the final (lower weight) version on Shapeways. They create a better quality with their powder-laser-3d-printer then I can achieve with my Ultimaker. The system is a two-part set and can be ordered in several colours...

Hi, yes you need the PMU. No, you cannot record the osd data on the GoPro. But With a Flytrex and Dashware you can achieve good results... Sent from my Nexus 7 using Tapatalk

The BTU unit does not advertise itself like other bluetooth devices do. You have to start the Naza assistant on the iPad/iphone which will connect with the hidden bluetooth connection of the BTU. Verzonden vanaf mijn iPad met behulp van Tapatalk

The BTU unit does not advertise itself like other bluetooth devices do. You have to start the Naza assistant on the iPad/iphone which will connect with the hidden bluetooth connection of the BTU. Verzonden vanaf mijn iPad met behulp van Tapatalk